Stainless Steel High Pressure Fittings for Spiral Pipe

A wide variety of round fittings are produced for high pressure including 90, 60, 45 and 30 degree elbows as standards, tees, laterals, reducing laterals, reducers, couplings, end caps, crosses, etc.

Fitting ends are made with two inch male sleeves. Standard fittings have built-in slip type beaded couplings.

Fittings:

Lapping of seams are in the direction of air flow. The finest continuous weld seams are made with Metal Inert Gas Shielded Welds (MIG).

SMACNA STANDARDS:

Maximum 10” S.P.:

SSHPspiral-fittings-chart1

 

 

 

 

 

For elbows, a wide variety of different radii are available; one and one-half diameter to centerline is standard.

Entrance Edges:

Particular attention is given to the entrance for conical tees, straight tees, and laterals. These fittings have a special rounded entrance edge. They are not butt welded square entrance contractor type fittings.

Fittings are machine cut on a scientifically developed, well proven, original pattern, assuring manufacturing tolerance consistency.

Fittings are machine cut on our State-of-the-Art Vulcan Plasma table, assuring manufacturing tolerance consistency.

Specialty Fittings:

Specialty configurations are available upon request. Some examples are as follows: Elbows (75, 15 and other degree angles are also available), a wide variety of different radii are available. Flange connections are available by the following, but not limited to: Angle Rings or, AccuDuct, Spiral Mate.

Construction Standards:

As listed in the current SMACNA HVAC Duct Construction Standards. Other regulatory construction standards are available upon request.

Comments are closed